Newport Coastal 7791-03B Installationsanleitung

Stöbern Sie online oder laden Sie Installationsanleitung nach Nein Newport Coastal 7791-03B herunter. Newport Coastal 7791-03B Installation Guide Benutzerhandbuch

  • Herunterladen
  • Zu meinen Handbüchern hinzufügen
  • Drucken
  • Seite
    / 2
  • Inhaltsverzeichnis
  • LESEZEICHEN
  • Bewertet. / 5. Basierend auf Kundenbewertungen
Seitenansicht 0
Figure 1
Mounting Screws (B)
Ground Wire
Cross Bar (A)
Outlet Box
Figure 2
Cross Bar (A)
Figure 3
Caulk
Fixture
Mounting
Screw (E)
Globe (F)
Fixture (D)
Fixture (D)
Wire Connectors (C)
Ground Wire(s)
OUTDOOR SECURITY LIGHTING FIXTURE
INSTALLATION INSTRUCTIONS
MODEL NO. 7791-03B
Congratulations on your purchase of a Newport Coastal ‘Outdoor security lighting xture.’ You have purchased a safe, dependable, and easy-to-install lighting system. You can use this xture at home for outdoor lighting applications.
WHAT’S INCLUDED: A - Cross Bar B - Mounting Screws (2) C - Wire Connectors (3) D - Fixture Base E - Fixture Mounting Screw (1) F - Globe
Tools Required: Phillips Screwdriver, Silicone Sealant or Caulk
IMPORTANT SAFETY INFORMATION
THIS PRODUCT MUST BE INSTALLED IN ACCORDANCE WITH ALL APPLICABLE INSTALLATION CODES.
IF YOU ARE NOT FAMILIAR WITH ELECTRICAL WIRING, IT IS RECOMMENDED THAT YOU SECURE THE SERVICES OF A WELL QUALIFIED ELECTRICIAN WHO CAN ASSURE THAT THIS
INSTALLATION MEETS LOCAL, STATE, AND NATIONAL CODES.
BE SURE POWER IS TURNED OFF AT THE MAIN POWER PANEL OR FUSE BOX PRIOR TO INSTALLATION OR REPLACING FIXTURE.
Before installing this xture, be sure to check with local ordinances regarding approved outdoor lighting. This xture style may not be allowed in some areas.
This xture is for outdoor use only.
This xture should be mounted to a grounded junction box marked for use in wet locations.
The electrical system and the method of connecting the xture to the system must be in accordance with local, state, and national electric codes.
This xture is to be connected to a 120 volt, 60 Hz power source. Connecting to a different power source may create a hazard and will void the warranty.
This xture is suitable for wet locations.
Do not use near or around ammable/combustible material or liquids.
Never use a lamp (bulb) with a higher wattage than the stated maximum allowed on this xture. Using a higher wattage lamp may cause a re hazard and/or damage to the unit.
The lamp (bulb) and xture can get hot during use. Turn off the power and allow the xture to cool down for at least 10 minutes prior to working on the unit.
FOR FLUORESCENT LAMPS (BULBS) – COLD WEATHER STARTING INFORMATION: For temperatures below 30°F, leave the lamp on continuously – starting with a warm lamp (bulb). If
starting becomes difcult in cold weather applications, remove lamp (bulb) from xture (note safety information above), bring the lamp (bulb) indoors to warm, re-install lamp (bulb) into
the xture – then leave on continuously. Do NOT place CFL lamps (bulb) in oven, microwave or similar heat producing device.
PRIOR TO INSTALLATION: Carefully read through the entire installation instructions before installing this security light xture.
WARNING: BE SURE POWER IS OFF AT MAIN POWER PANEL/FUSE BOX BEFORE INSTALLING OR REPLACING FIXTURE. THIS PRODUCT MUST BE INSTALLED IN ACCORDANCE
WITH THE APPLICABLE INSTALLATION CODES BY A PERSON FAMILIAR WITH THE CONSTRUCTION AND OPERATION OF THE PRODUCT AND THE HAZARDS INVOLVED.
INSTALLATION INSTRUCTIONS
BE SURE POWER IS TURNED OFF. Remove old lighting xture. If installing at a new location, contact a qualied electrician.
1. Attach cross-bar (A) to junction box with mounting screws (B) – Figure 1.
2. Connect wires using twist-on wire connectors (C) – Figure 2.
- White wires from the xture (D) to the white wire from the junction box.
- Black wire from the xture (D) to the black wire from the junction box.
- Bare copper ground wire from the xture (D) to the ground wire (bare or green) from the junction box.
3. Position the Fixture Base (D) over the junction box and secure in place using the xture mounting screw (E). Screw to be placed into mounting hole o xture base (D), then
threaded into hole located at center of cross bar (A) – Figure 3.
4. Screw lamp (bulb) into socket. Lamp (bulb) not to exceed 60 watts. See safety information above.
5. Screw globe (F) into xture base (D). Do not over-tighten.
6. Use a clear silicone caulk around the outside of the xture base to provide a water-tight seal when xture is installed.
7. Turn power back on.
TROUBLESHOOTING
Does not function at all
Make sure wall switch (if applicable) is ON and that the wiring is correct.
Check that the circuit breaker, fuse, and main circuit breaker or main power switch are ON.
Check lamp (bulb).
Made In China
© 2012 Hampton Products International Corp.
999-60885_7791-03B_REVA 1/12
LIMITED LIFETIME WARRANTYThis product is warranted to be free from defects in material and workmanship for life of product. If a defect occurs, call 1-800-562-5625 for instructions on
how to have defective product repaired or replaced free of charge. LIMITATIONS - This warranty only covers Newport Coastal assembled lighting products and accessories and is not
extended to other components, Lamp Bulb(s), or equipment used on the product. Warranty extends to original purchaser of product. Receipt or other approved proof of purchase required for
warranty service. NOT LIABLE FOR INCIDENTAL, INDIRECT, OR CONSEQUENTIAL DAMAGES. Some states do not allow the exclusion or limitation of incidental or consequential damages, so
the above limitation or exclusion may not apply to you. This warranty gives you specic legal rights, and you may also have other rights which vary from state to state. NOT COVERED -
Product failure not relating to faulty material or workmanship, corrosion of brass components, reimbursement for installation or unauthorized service.
Hampton Products International Corp.
50 Icon, Foothill Ranch, California 92610-3000
Seitenansicht 0
1 2

Inhaltsverzeichnis

Seite 1 - MODEL NO. 7791-03B

Figure 1Mounting Screws (B)Ground WireCross Bar (A)Outlet BoxFigure 2Cross Bar (A)Figure 3CaulkFixtureMountingScrew (E)Globe (F)Fixture (D)Fixture (D)

Seite 2 - MODELO NO. 7791-03B

Figura 1Tornillos de montaje (B)Cable de conexión a tierraBarra transversal (A)Caja deempalmesFigura 2Conectores de cable (C)Cable(s) deconexión a tie

Kommentare zu diesen Handbüchern

Keine Kommentare